![]() ![]() Knowing the surface you are working on will also determine the type of drill bit that you use. You’ll also want to make sure you have all other tools on hand including a vacuum, a wire brush (with a diameter of the drill hole), and a hammer drill. Before Using a 3/16” Tapconīefore using a 3/16” tapcon, it’s important to have a clear plan for the project you are planning on doing. ![]() For all your heavy duty jobs where harder hammering is required with a drill, this is the bit style that will prove itself useful. SDS or spline drive systems can be used on hammer drills that use a chuck that you can disconnect quickly. These ones have sides that are round or flat so they can easily fit into the chuck. Straight Shank bits will be used for Jacobs Style chucks (which uses a chuck key). These include straight shank and SDS bits. Keep in mind that there are other drill bit styles that you can use to drill holes into harder materials. Light pressure should be good enough to apply for this process. Using a rotation drill, you can slowly screw it in. After the hole is cleaned, install the tapcon screw into the pre-drilled hole.For better results, stick with a vacuum during the prep process. You can use compressed air as an alternative, but it can affect the air quality in your immediate area. With a twist and turning motion, clean the hole and use a shop vac or vacuum. ![]() Make sure the wire brush is the same diameter of the hole that you drilled. This is also a good time to use a wire brush to clean the inside part of the hole. ![]() You need to clean off the area and ensure there is no dust and debris anywhere.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |